To use the Power button to record data:
- Set the receiver power to ON and look at the LED screen to make sure that the receiver is prepared.ADDITIONAL INFORMATION:When the Power LED does not flash yellow, the receiver is prepared to record data.
- Push the Power button three times in 2 seconds to record data.
- Make sure that the REC LED flashes green, which shows that a *.tps data file is open and a data recording process started.
- The REC LED flashes during the data recording process.ADDITIONAL INFORMATION:If the REC LED flashes red, the internal memory is near full.
- Push the Power button three times in 2 seconds to stop the data recording process.
- Make sure that the REC LED does not flash.
Previous:
Data recording
myTopcon NOW! support
Take your Topcon experience to the next level with myTopcon NOW! This platform is a self-service tool for your desktop or mobile device.
