- Make sure the recommended system/component software and firmware listed in the table below are installed before starting machine installation.
- Device software and firmware must be loaded in the order listed in the table below. Only update device software and firmware if necessary.
- Go to https://www.topconpositioning.com/support/updates to download software and firmware.
| Device | Firmware and software |
|---|---|
| 3D-MC | 3DMC.DZR.AM.15.1.9.100 or newer |
| MC-X1 controller | 3.2.30 or newer |
| MC-X3 controller | 3.2.305 or newer |
| GR-i3/GR-i3F (mainboard) | 2.86 or newer |
| GR-i3/GR-i3F (GNSS) | 5.5.2 (B111) or newer 5.5.2 (B111A) or newer |
| TS-i4 | 2.0.15 or newer |
| SATEL TR-49 (MC-X3) | 7.45.2.5.1.20 or newer 7.60.3.6.0.5 or newer |
| GX-55/GX-75 | Gen 1 1.25 (mainOS) 1.25 (safeOS) 1.25 (eboot) Gen 2 5.05 (mainOS) or newer 5.05 (uboot) or newer |
| SL-25 | 1.23 or newer |
| SL-100 | 1.23 or newer |
| MCXConfig | 1.0.3.6 or newer |
| Topcon Receiver Utility (TRU) | 3.6 or newer |
| UR-1 radio | 2.0.9 (bootloader) 1.8.2 (UR_1 firmware) 2.2p4 (R2C) |
| LSB-series | LSB110WCAN_Ver103 |
Refer to the following for further information on updating firmware/software:
- MC-X3 or MC-X1 Controller: “MC-X Connectivity and Configuration”
- GR-i3/GR-i3F: “GR-i3 Firmware" and "GNSS Firmware"
- TS-i4 sensors: “System Verification”
- UR-1: “Load UR-1 Firmware”
- SATEL TR-49: “Load TR-49 firmware”
- GX-Series display: “GX-Series Display on the Machine”
