Elevation Control configuration

Specify the design surface offset. For example, if you enter a value of 1.00 ft. (0.3 m) for the design surface offset, the grade is 1.00 ft. (0.3 m) higher than the design surface.

If a value of -1.00 ft. (-0.3 m) is entered, the grade is 1.00 ft. (0.3 m) below the design surface.

If it is necessary to keep an offset from the design surface, you can change the design surface offset. For example, to decrease overbuilt areas to grade or manage lifts for fill material.

The cut/fill updates continuously concerning the elevation difference between the cutting edge and the design surface.