| Blade is moving too slowly. The blade seems to move too slowly in Control mode. The grade indicator takes too long to reach grade | |
| Cause | Solution |
| The Valve Offset is too low | Increase the valve offset value which will increase the hydraulic speed. Check which control is slow before adjusting the Valve Offset value. Remember a larger value will speed up valve response. |
| Blade reacts but does not reach On Grade | |
| Cause | Solution |
| The Valve Gain setting is too low | Increase the valve gain setting, which will cause the hydraulics to respond quicker. Increase the value to a number that makes the cutting-edge reach grade quickly without overshooting grade. Check which control function is too slow before adjusting the Valve Gain. Remember a larger value will speed up valve response. |
| Blade reacts but overshoots On Grade | |
| Cause | Solution |
| The Valve Gain setting is too high | Decrease the valve gain setting, which will cause the hydraulics to respond slower. Decrease the value to a number that makes the cutting edge reach grade quickly without overshooting grade. Check which control function is too fast before adjusting the Valve Gain. Remember a lower number will decrease valve response. |
Previous:
Troubleshooting
Next:
IMU sensors
myTopcon NOW! support
Take your Topcon experience to the next level with myTopcon NOW! This platform is a self-service tool for your desktop or mobile device.
